Installation Instruction
Switch installation place should better locates on the wall for 1.4m from the floor, and 0.2m from door gate
· Socket installation place is dependent on different enviroement:
Living room: 30cm from the floor
Kitchen/Restroom:1.4m from the floor
Air conditioning socket: 1.8m from the floor
· The distance between socket and power cable should be more than 50cm
· Advise to use water-proof plug, socket in rest room.
· Advise light switch for rest room to install outside the rest room to avoid water get into the switch to affect life time or cause accident.
If you're unsure about working with electricity, you should call a licensed electrician to do the work. But if you're ready to give it a try, let's go ahead and get started.
How to Install a Light Switch
Step1: Find the breaker or fuse that shuts off the circuit that you will be working on. Make sure it's in the off position.
Step2: Double check that the power is off by testing the light switch you're replacing. Flip it on and off several times. If the light stays off, you've turned off the right circuit.
Step3: You can use a voltage tester near the light switch to check for an electric current.
Step4: Take off the switch plate by removing the two screws that secure it to the light switch. Use an alternative light source if you can't see what you're doing.
Step5: Remove the screws holding the switch to the electrical box in the wall.
Step6: Pull the switch out of the box. Remember the way the existing switch is wired. Take a picture or write down if needed.
Step7: Remove the old wires.
Step8: Make sure the new switch is oriented properly before putting it in. The word "TOP" should tell you which end goes up.
Step9: Reconnect the wires. Wrap a little more than 1/2-inch of the stripped wire clockwise around the terminal screws and tighten with a screwdriver. Connect the black wire to the brass screw and the neutral wire to the silver screw. Connect the ground wire to the green screw on the opposite side of the switch.
Step10: Carefully push the switch back into the box and secure it with screws.
Step11: Screw the switch plate back on.
Step12: Turn the power back on and test the connection.
